Yes. Measure from the tractor drawbar to the first row of shanks/discs/whatever. 2630 needs to know this to calculate where the toolbar is for mapping. Also section control if you are using that.
My 2600 allows you to set up the tank as the first implement with all its measurements, and the bar as the second implement. Pretty sure a 2630 would also allow this.
If you set it up as one unit it will draw the coverage much shorter in the turns, and any curved track guidance will be way out from where it should be.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
The Combine Forum
884K posts
52.3K members
Since 2005
A forum community dedicated to all combine owners and enthusiasts. Come join the discussion about specifications, accessories, troubleshooting, maintenance, and more!