 |
|
|
 | ||
       |
 |
10-02-2011, 11:40 PM
|
#1 (permalink) |
 Site Sponsor
Join Date: Jan 2011
Location: Ontario Canada
Posts: 83
|
EkotuningCom Video Thread
I'll post some random videos in here from time to time. A lot of the video will be related to our current activites but without too much commentary or a sales pitch. Just for your interest, if you're interested.
JD 9330 being dyno tested before tuning and again after. This test is setup to start at 1100 pto rpm @ full throttle. The dyno will automatically begin applying a load in 50 rpm increments with 4 seconds to stabilize down to 600 rpm. Fendt 818 Last edited by Jari; 10-02-2011 at 11:46 PM. |
|
|
| Sponsored Links | |||
Advertisement | |||
|
10-03-2011, 12:13 AM
|
#2 (permalink) |
|
Site Sponsor
Join Date: Jan 2011
Location: Ontario Canada
Posts: 83
|
pulling video
Wellington County King of the Pull event was a lot of fun. It's a pulling series put on by the Drayton, Grand River and Fergus Agricultural Societies and sponsored by Lardeb and Shawridge Farms to promote participation by local farmers. The competition is decided by points from 3 different pulling events with 2 weight classes. We were proud to sponsor both classes (22000 and 32000 lbs). The competition was fierce and an awesome turnout to each event made it exciting.
Results: 32000lb = JD8345R 54 points, JD8270R 48 points, Agco DT240a 47 points 22000lb = Fendt 926 60 points, JD7930 56 points, Fendt 926 53 points Second Place 32000 lb Last edited by Jari; 10-03-2011 at 12:21 AM. |
|
|
|
|
11-13-2011, 06:20 PM
|
#3 (permalink) |
|
Site Sponsor
Join Date: Jan 2011
Location: Ontario Canada
Posts: 83
|
JD 9220€ Dyno video
|
|
|
|
|
01-10-2012, 01:53 PM
|
#4 (permalink) |
|
Site Sponsor
Join Date: Jan 2011
Location: Ontario Canada
Posts: 83
|
Massey Ferguson 5465
MF 5465 with 6.6 Perkins
Dyno tested at 120hp @ 1000rpm pto with OEM program. After tuning its making 265 hp @ 1000 rpm Dyno test procedure: -warm up both tractor and dyno by holding a small load -tractor at full throttle through out entire dyno test -step test from max pto rpm, down to 700 rpm in increments of 50 -dyno automatically applies a load in 50 rpm increments (ie. forces the tractor to slow down by 50rpm) and holds it there for a few seconds to obtain reading. Last edited by Jari; 01-17-2012 at 10:45 PM. Reason: update video url |
|
|
|
| Sponsored Links | |
Advertisement | |
 |
| Thread Tools | |
|
|
