The Combine Forum - View Single Post - FD140 tilt issues
View Single Post
post #8 of (permalink) Old 07-30-2018, 09:26 AM
Transaxial
Senior Member
 
Join Date: Jun 2012
Location: east central Alberta
Posts: 1,269
Mentioned: 0 Post(s)
Quoted: 258 Post(s)
Quote:
Originally Posted by Jason Anderson View Post
We bought a new FD140 this year on a Case 8230. The adapter has the double float sensor option. I set the header up properly according to the book, but when I use AHHC it wants to tilt to the right, or positive 0.6 to 1.1 degrees. Any suggestions on fixing this problem? Im in rigid mode cutting wheat.
Does that mean the adapter has two sensors, a left and a right. Which should mean it can auto tilt side to side hydraulically and not just floating on the springs? My first thought was the older ones needed a Y cable to feed header signal to both sides of the combine sensor system or it would try to lift one side only, getting things off level. I think I am behind the learning curve on your problem though???
Transaxial is online now  
 
 
For the best viewing experience please update your browser to Google Chrome