TM190 3pt hitch issue - The Combine Forum
 
LinkBack Thread Tools
post #1 of 7 (permalink) Old 05-22-2019, 02:52 PM Thread Starter
Junior Member
 
Erwin19's Avatar
 
Join Date: May 2019
Location: Ontario, Canada
Posts: 2
Mentioned: 0 Post(s)
Quoted: 0 Post(s)
TM190 3pt hitch issue

Hi, I have a TM190 with the following problem: when I start the tractor and the 3pt hitch doesn't move up or down the tractor doesn't drive neither forward nor backwards. Sometimes I can turn it off, wait a while and when I turn it back on all works well again. If the tractor doesn't work the yellow sign with the book is off but when the tractor works the sign is blinking. Any ideas? I am out of ideas.

Erwin19 is offline  
Sponsored Links
Advertisement
 
post #2 of 7 (permalink) Old 05-22-2019, 08:35 PM
Senior Member
 
BoSoT's Avatar
 
Join Date: Oct 2013
Location: Western Cape, South Africa
Posts: 484
Mentioned: 0 Post(s)
Quoted: 120 Post(s)
What is the fault code? My 140 had trouble with hitch not lifting. Problem was with the potensio sensor on the right side of the lift. Didn't hinder the movement tho


Nou wat nou?
BoSoT is offline  
post #3 of 7 (permalink) Old 05-22-2019, 09:27 PM Thread Starter
Junior Member
 
Erwin19's Avatar
 
Join Date: May 2019
Location: Ontario, Canada
Posts: 2
Mentioned: 0 Post(s)
Quoted: 0 Post(s)
there is no code, that's what makes it so hard to find the problem
Erwin19 is offline  
Sponsored Links
Advertisement
 
post #4 of 7 (permalink) Old 05-22-2019, 09:30 PM
Senior Member
 
BoSoT's Avatar
 
Join Date: Oct 2013
Location: Western Cape, South Africa
Posts: 484
Mentioned: 0 Post(s)
Quoted: 120 Post(s)
If that little book is flashing, there should be a code

Nou wat nou?
BoSoT is offline  
post #5 of 7 (permalink) Old 05-22-2019, 10:50 PM
Junior Member
 
Join Date: Nov 2017
Posts: 9
Mentioned: 0 Post(s)
Quoted: 0 Post(s)
Sounds like a regulated pressure problem. Does the PTO work when it's acting up? If it doesn't I would remove the regulated pressure valve, take it apart, emery cloth the spool (fine grit), clean it up, put it back together and reinstall it. It is the very RH end slice on the valve stack and has the main pressure hose from the pump going into it if I remember correctly.
3D_Heavy_Duty is offline  
post #6 of 7 (permalink) Old 05-22-2019, 11:12 PM
Senior Member
 
Join Date: May 2011
Posts: 762
Mentioned: 0 Post(s)
Quoted: 126 Post(s)
Does it go away if you fully raise/lower the 3pt?
Or when flashing it won’t respond at all?

We’ve had ones where if they’ve sat for too long would forget where the arms were and the warning light would flash. Cycling the arms with either up/down buttons OR depth control slider fully up/down and back to where you want would clear the light and put it back to good/green.

Or are you describing something different(?)
adsinaus is offline  
post #7 of 7 (permalink) Old 05-23-2019, 04:58 AM
Senior Member
 
BoSoT's Avatar
 
Join Date: Oct 2013
Location: Western Cape, South Africa
Posts: 484
Mentioned: 0 Post(s)
Quoted: 120 Post(s)
Quote:
Originally Posted by adsinaus View Post
Does it go away if you fully raise/lower the 3pt?
Or when flashing it won’t respond at all?

We’ve had ones where if they’ve sat for too long would forget where the arms were and the warning light would flash. Cycling the arms with either up/down buttons OR depth control slider fully up/down and back to where you want would clear the light and put it back to good/green.

Or are you describing something different(?)
This is the same problem with my 140.
Switch on the ignition and leave it on for a while. Should show some codes. Otherwise you need a adapter/switch that plugs in under the hitch controle box that will show you the H fault codes if any. Ohh and make sure the altenator is working properly....

Nou wat nou?
BoSoT is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the The Combine Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Similar Threads
Thread Thread Starter Forum Replies Last Post
Sliding drill hitch for inter seeding. doorknob Fabrication and DIY Repair 3 04-23-2014 10:25 AM
Can Hesston 3x3 ball hitch get bigger? aarondeere Haying 2 11-20-2013 01:40 AM
480 stx quad ag hitch blair5002 Tractors 2 03-29-2013 02:51 AM
How Much On The Hitch Gregg Grain Carts 6 06-02-2012 11:06 AM
New Holland TM190 issue Sturdy53 Tractors 2 04-12-2012 05:16 AM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome