The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
Just started using cr940 for first time yesterday. Did about 10 acres just fine, but self leveling shoe tilted to 6 degrees and would not return to level while running on level ground,(not sure why it moved to 6 degrees since ground was level). Ran leveling shoe calibration and failed code 33. Now shoe is at 10 degrees. Any help would be great.

Also can the shoe be moved manually,(electricly or physically) back to level? And once back, can leveling be disabled?
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #3 ·
Just got in from field...Dealer came out this morning and did exactly what you suggested, and the motor tried to move but sounded like a slip clutch. Put in new motor and it worked, ran calibration and it passed. Eerything works ok. Thanks very much for your help,it was spot on correct. Do you have a service manual? If I have any more problems with combine I may need your help, because dealer is not a NH dealer,just got lucky and had a used cr960 on lot to take motor from. Thanks Again.
 
1 - 2 of 2 Posts
Top