The Combine Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
95 Posts
Discussion Starter · #1 ·
wanting to put a Trimble antenna in one combine for mapping purposes and and outback auto steer in the other. Where do I find a good keyed power source, I don't want to use the lighter plug as I need that for satellite radio.
thanks
Michael
 

· Registered
Joined
·
998 Posts
In the fuse compartment down on the base of the interior liner. Cannot remember if it's key or constant power, but good power and earth studs there. Also a power plug up in hood liner where radios go. Plenty of places to grab power from in there
 

· Registered
Joined
·
560 Posts
in Europe, CIH does the same thing due to regulatory requirements. I imagine Deere does it for Europe, and it's easier to have one set of panels/latches than multiples, so they just keep the same style for the US market.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top