The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
836 Posts
Discussion Starter · #1 ·
It always seems to generate some interest when I post over here, so I keep doing it. :)

Doing a Fuel & Service bed was one of the first things I wanted to do when I started looking into 3D printing, then I started seeing what it could do so I wanted to push the norm a bit and see if I could get the doors to open also to add a bit of realism. The good new is it WORKED!
Each side, along with doors in printed in high detail so it is printed in a single piece with movable parts. I increased the tolerances in the doors a little bit after getting my first pieces just to make painting easier. You do still have to paint in light coats though.
It is a really easy kit to assembly, just glue the sides on an paint.
The body: 1/64 Service & Fuel Body Part 1/2 by miniskfarm on Shapeways
The sides: 1/64 Service & Fuel Body opening doors - Part 2/2 by miniskfarm on Shapeways









 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top