The Combine Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Hi all would any one have the info on how to the adjust the clutch on a cr 1225 out of the work shop manual and could email it to me thanks a bunch !
 

·
Registered
Joined
·
3,461 Posts
What I find works good to measure the 1/2 inch between the release bearing and forks is a long bolt with a 1/2 inch head.
 

·
Registered
Joined
·
855 Posts
Hi all would any one have the info on how to the adjust the clutch on a cr 1225 out of the work shop manual and could email it to me thanks a bunch !
This the odd ball model Steiger with the Allis Chalmers transmission?
I don't think those have a dry engine clutch per say.
 

·
Registered
Joined
·
455 Posts
This the odd ball model Steiger with the Allis Chalmers transmission?
I don't think those have a dry engine clutch per say.
I'm pretty sure they are a allis trans and clutch assemblly. I remember havin one apart at jd years ago but don't remember much more then that. If its a wet clutch chances are there no adjustment.
 
1 - 6 of 6 Posts
Top