The Combine Forum banner
1 - 1 of 1 Posts

· Registered
196 Posts
Discussion Starter · #1 ·
Does anybody know if the auger flighting on 1010 header is special abrasion resistant steel or if it is simply mild steel? We are doing some work to our auger and building the flighting back up to where it was originally and wondering if the new flighting should be spray-torched or if there is any need. Thanks
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.