The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
i have a case 1020 header and today i went to use it for the first time of the season. when i tried to set up auto header height it always just went straight into the ground and when i tried to raise the dial on my 1660 combine it wouldnt go down anymore. finally got it the the right height on the ground where it would drop but then the head wouldnt raise or lower it just rides at the same height. Any ideas?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top