The Combine Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
i need to remove the shaft that drives the knife rollers, and just wandering what all i need to loosen on the shaft to get it out, its got the spocket and bearing on the left side that drives the cross auger, and also the tech said that bearing on the outside might have a collar lock on the inside but it dont and also that it might have a snap ring on it, but i didnt see any any help getting out would be great have to replace the hub on the second row
 
1 - 1 of 1 Posts
Top