[crawfordfarms]

The unload auger on my 1460 goes out just fine then is very slow to come in, almost like it is gravitying in. It only comes in about 2/3 of the way then stops. My wife can hold the switch in and i can pull it in by hand. I put a kit in the cylinder and both poles of the sylinoid are magnatized like they are supposed to be. Any ideas on what else i should try I'm at my wits end.

 

[steigerman]

Check to see if the master solenoid is energized you may have burned out a diode.

 

[steigerman]

Both poles energized? One should be ground.

 

[crawfordfarms]

The service manual says to check diagonally across, and they both are magnetized.

 

[farmertony]

grease?

 

[crawfordfarms]

problem fixed, the fore aft selecter valve was messed up so i just took it out and put it back like it came from the factory and it works perfect. If I ever get a fore aft reel ill just have to put a new valve in