The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
My 1020 Reel Moves forward gradually when plugged into Fore/Aft outlets on my 1640. When unplugged it won't move, but when plugged in it will move forward a few inches in 30 minutes, or sometimes less when my hoses are plugged in. It seems like the solenoid valve is letting a small amount of oil by. Is this possible? or should I be looking elsewhere for the problem. What about the needle valves and seats in the solenoid? Should I just replace them and see what happens. Also, there isn't any oil leaking anywhere on the lines.

I need to get this fixed before I can use my hydraulic stripper plates on my corn head.
 
1 - 1 of 1 Posts
Top