The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
1660 unloading auger seems to slam to a stop when i swing it out. I have never noticed the past 2 years I ran it. New vert.tube and all old grease cleaned off. By slam to a stop it will bounce back and forth a couple of times. Did'nt know if there was a way to slow down the speed.
Thanks for any ideas.
Steve
 

·
Registered
Joined
·
352 Posts
im going to take a shot at it but im not sure isnt there a limit switch on the unloading auger telling it when to stop when it is fully swung out if there is it maybe needs to be adjusted just an idea but im not for sure
 

·
Registered
Joined
·
591 Posts
Check the bolts on the elbow where the cylinder attaches. These bolts may be loose letting the auger bounce when it extends
 
1 - 3 of 3 Posts
Top