The Combine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I'm looking for the thrust bearing on the axle spindle of a 1666 Combine. The one that is in the parts book is the wrong size. The size I need is 2.875" outside diameter, 1.675" inside diameter. Has anyone run into this problem before? Know where I can find one?
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
No, the new bearing is not labeled wrong, I checked into it with IH. There are no numbers on the old bearing. Have checked with bearing manufacturers but with no leads.
 
1 - 5 of 5 Posts
Top