[boredfarmer]

When I engage the automatic header height control and use the dial to adjust the height, when the header is roughly 4 inches from touching the ground, the header lowers itself all the way down with no control. Is this a an accumulator issue or electronics? any help will be appreciated. Thanks

 

[robmgrig]

Do you mean the header bottoms out and won't float? If so sounds like the potentiometer is not adjusted right

 

[boredfarmer]

yes it bottoms out and will not float.

 

[robmgrig]

If the cable and everything under the bottom is free then loosen the not on the potentiometer shaft and rotate it back and forth until your header floats. Then fine tune it by rotating it in very small increments until the header comes just off the ground and stops with the height knob set to it's highest position. It should work right then. If the header won't come up at all then your potentiometer may be bad

 

[boredfarmer]

Thanks for the info. I'll give it a shot this weekend when off from work. I had a feeling that it was what the problem was. once again, thanks!