The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi guys i hope someone can help me out just bought a f gleaner and when u push the gound speed control the clucth with not move and there is lots of per sure to that little cylinder by the clutch is there someelse i got ot do to make it work .....

Thanks
 

·
Registered
Joined
·
1,090 Posts
is the lower torque sensing sheave moving in and out as well? If not, you are putting a bind on things and getting the belt too tight. the torque sensing sheave needs to open up when the mainshaft sheave closes together, and vice versa going the other way.

if it is froze up, you might have to disassemble it. Usually proper greasing keeps it freed up.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top