The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
We just bought a 2013 550 quad this spring and it has about 700hrs on it. We pulled a field cultivator with it this spring and notice no issues. Now this fall we have pulled a 30ft chisel plow with it and a 9 shank ripper and now that its under a decent load when pulling it seems to have a bad drivetrain vibration. Has anyone heard of this and what the issue is or the fix may be? It's not fun to run anymore. Thanks.
 

·
Registered
Joined
·
2,232 Posts
Inspect dampner that bolts to flywheel/attaches driveshaft to transmission, should be no cracks visible, check u-joints, on rear of transmission to rear pivot point, there are bolts that retain carrier, is shaft centered? Scott.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top