[beagleboy27]

A 2062 or 974 Macdon needs to have a gaurd angle reduction kit put on it if it is to run on a 6088 or 7010. The 2062/974 were based off of the 2388 feeder house. Taller tires on the 6088 and 7010 made the gaurd angle too steep. The kit is built into the new 2162 or MacDon FD70 faceplate.

 

[beagleboy27]

If your retractable teeth are that close they should be taken out and block out plates put in. The front hole may cause the Drum to hit feeder house if the drum is not all the way up. If you have the gaurd angle plate on and still have trouble, check to see if the adpter legs are in the right hole position under the head. There is three hole that the pin can go into. I have seen alot that were put together wrong at the dealers. Also might check the front transinon pan that hooks the bottom of the feed deck to the front of the cutterbar. If this is not set to 3.5" it can bind up and not let the head float.