The Combine Forum banner

2130 bourgaut metering

1035 Views 4 Replies 4 Participants Last post by  holoj
Hi. I have to reseed some canola. I picked the same setting I used previously and it have me 5 lb per ac. I was applying fert at same time. Now I'm applying just seed and my rate is all over. Way to low and even if I go to smaller sprockets it still is too low. I used a 42 tooth before. and now I'm on 35 and still not good should i throw seed in front tank and take off drive chain or to I adjust dual pressurization valve? Thank you
1 - 1 of 5 Posts
I cant remember for sure but I believe there is a pipe that goes between the two tanks on the inside just below the lids. If you are just using the one tank there is a cap you screw on this pipe, I believe our 2155tank was set up like this.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.