The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
- was combining black beans other day with my 97' 2144 and had to change knife section
- touched the gaurd with my hand and got a shock, it wasn't a snap and it was over like static, but a steady pinching feeling like a DC current would give you, I ended up having to ground the header with a piece of steel in order to replace the knife section
- went to dump stone trap and had same feeling there too
- does anyone know why it would do this, sometimes its there other times its not
- (I'm running an air reel if it makes a difference)
 

·
Registered
Joined
·
125 Posts
Do you have a drag chain somewhere on your combine to ground it? If not, I would put one on. Ours is installed below the pivot on the rear axle of our 2388.

Warren
 
1 - 2 of 2 Posts
Top