The Combine Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
1,644 Posts
Discussion Starter · #1 ·
New to us 2011 2152 header for out 8120 was an awesome investment. Cut 2 quarters with it this weekend. But it doesn't have AHHC sensor, plus when I hook it up to combine, we don't even get a manual height indicator on the pro600. Is that normal? Its kinda hard to see at night really how high you are cutting.
 

· Registered
Joined
·
1,644 Posts
Discussion Starter · #3 ·
Ya I didn't get a chance to call today to find out how much HHC is, I assume you can get a kit. A week to install it though? Not sure I read that right....

I did change the settings in toolbox on head 1 and 2 on the pro600, but manual height doesn't say anything, just ---.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top