The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
131 Posts
Discussion Starter · #1 ·
When I try to calibrarte my header on my 2188 when I get to the part that lets the header down I get a code; Huo Open/short to ground-raise solenoid circuit failure. I have the corn head on and the header control works and the button in the cab works. Does this mean the raise solenoid is going bad and I should replace it or is there other posibilities?
 

·
Registered
Joined
·
998 Posts
For starters take your corn head off so it can do a proper calibration below ground level. Does it do it every time or have you only tried it once? Sometimes you can turn the key off and try it again. As for the code - sorry, I would have to look into it.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top