The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
On a 2366 with auto AC it has no cold air but the fan works. If you put the switch into the middle position for manual AC the fan wont work at all.There is no code coming up on the little thermometer. Anyone run into this? The AC worked fine 3 days ago.
 

·
Registered
Joined
·
153 Posts
Quote:On a 2366 with auto AC it has no cold air but the fan works. If you put the switch into the middle position for manual AC the fan wont work at all.There is no code coming up on the little thermometer. Anyone run into this? The AC worked fine 3 days ago.

When we had a 2366 about 4 years ago, It never had problems like this. When our neighbor had a 6620 T2 it had the same problem. He dug into it and found that a mouse had built a nest in near the fan and it was blocking all of the air that was going to the vent. Might want to check this out.
 

·
Registered
Joined
·
619 Posts
Middle switch position is "off". When you first turn the a/c on it will be in auto mode. Turn the fan speed dial it should change to manual mode and you can control the fan speed manually. Make sure there is nothing blocking the air intake for recirculation system behind the operators seat eg: Rags, coveralls, jacket etc.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top