The Combine Forum banner

2366 Automatic Header Height control question.

8K views 3 replies 4 participants last post by  Alex.moolman 
#1 ·
Traded off my 1988 1640 for a 1998 2366. Checking out my 1020 platform and the AHHC does not work. I think it's the potentiometer.

Which potentiometer do I need?

Thanks.
 
#3 ·
If your potentiometer is black you will need to change it for the correct one, smaller size with the transparent back and you will need to change the mount plate too to accomodate the alignment pin on the new pot to adjust it properly.
Read your manual, you have to calibrate the "pot" on the header to the combine before the system will work properly once the correct sensor is installed.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top