The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
Is there any way to adjust the electronic concave position sensor on a 2366? I have the concaves set on 0 but the electric readout in the cab reads 1.9 I would like to set it to zero if possible.
 

·
Registered
Joined
·
28 Posts
It will be a step under in the Header Calibration setup. Be sure and have your concave's tight (fully closed) when you set to"0".
 

·
Registered
Joined
·
3,334 Posts
you will hold two buttons togeather on the a post....and then hit up and down to go threw the menu up to change and down to continue on in the list of options.... (if i remember right)

YOu will see something like Concave and when you hit the up button im thinking it then zero's it out....im pretty sure when your done you just turn the key off....

like the guy said grab the book and its very simple and easy..
 

·
Registered
Joined
·
17 Posts
Discussion Starter · #5 ·
When you mean tight (fully closed) do you mean concave as tight as it will go or just when the high bar just touches?

I was figuring zero when the high bar just touches the concave.

Thanks for all the help!
 
1 - 5 of 5 Posts
Top