The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
82 Posts
Discussion Starter · #1 ·
I have a 2388 combine I bought last year so I am new to the proper settings on the concave of a rotor.
I have noticed that the concave mounting plate on the left hand side of the combine that adjust the concave clearance is not adjusted to where it is straight across. There is a 2 inch gap on the front of the plate between the plate and the rotor cage the rear of the plate is flush with the cage. Is this correct?
 
1 - 3 of 3 Posts
Top