The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter #1
trying to pre set my 2388 for wheat harvest. book says 1050 in high gear for rotor. i put it in high and held the rpm increase button. it quit around 950 ish? it is touching the limit switch and it looks like the speed adjustment and the pulley is bottomed out. what do you do in this situation?

thanks.
 

·
Registered
Joined
·
127 Posts
is the belt at the top of the drive pulley? you can move the driven pulley to adjust the speed If its bottomed out the correct way you may have the wrong belt on it. More than likely the belt is to long thats on it if my memory is right I run two 06's and a 04 the 04 takes a different belt but I changed it to the same belt so I only need one spare had to move the driven pulley the one on the rotor to get my speed right it only goes to 1020 but that works for me.

Does your engine go to full speed?
 

·
Registered
Joined
·
80 Posts
Discussion Starter #3
dont know if its the right belt or not...combine is new to me. i will check to see if the engine will turn the rpms it is supposed to.
 
1 - 3 of 3 Posts
Top