The Combine Forum banner

2388 tailings auger trough

2481 Views 1 Reply 2 Participants Last post by  cornstalks
Anybody replaced the tailings auger trough? If so do you need to remove the lower sieve rails and grain pan assembly" Thanks
1 - 2 of 2 Posts
you need to pull the sieves and pull the bolts out of the the shaker rails top and bottom and I put a cable comealong on them and lift them up enough to get the trough out. you actually can leave the front bolts in in the rails just loosen them. tie the cable for lifting to the chopper or beater
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.