The Combine Forum banner

2388 Vertical unload auger

6039 Views 7 Replies 7 Participants Last post by  arcticcatfarmer
Took out the vertical unload auger in a 1660 a couple times and took it out the top. On my 2388, is it easier to go out the top or down thru the bottom? Any other tricks other than watch for timing of horizontal? Am going to put on plastic flighting. I also need to replace the outside tube on the horizontal unloading. Any after markets better than others? Thanks.
1 - 1 of 8 Posts
The plastic flighting would probably work well in soybeans and small grains, but I wouldn't even think about trying it in rice. That stuff is more abrasive than sandpaper. Corn I'm not sure about. Maybe it'd work, Maybe not. Just depends on the plastic.
Len, keep us posted on this.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.