The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I'M new to this forum, so I hope this gets posted correctly. Looking at upgrading to a CaseIH 2588 and a Macdon 974 30ft. 2588 is a 2007 PRWD and 2 speed hydro. Does not have the 3rd feeder lift cylinder. Previous owner ran a 30ft 1020. The 974 was previously on a 2388. Will the current hydraulics on the 2588 hookup like the 1020? How do I control the pitch of the cutter bar?

Thanks, Buffaloman
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top