[Kosie Loubser]

Why does my 2 displays(2630) in my S670 Combine show different yields? Anyone know how to fix it? Thanks

 

[STR1]

Maybe different settings or calibrations in the 2 screens?
Why do you have 2-2630s in the S670?

 

[s6704940]

Is one set to dry yield and one set to wet yield?

 

[Auscocky]

Why does my 2 displays(2630) in my S670 Combine show different yields? Anyone know how to fix it? Thanks

Get rid of the screen that shows the lower yield.
Fixed...

 

[phantom970]

Get rid of the screen that shows the lower yield.
Fixed...

Did you do any crop this year with the 9870?

 

[Auscocky]

Did you do any crop this year with the 9870?

No, did the bit we had with the 9750. I'll sell the 9750 when the timings right. Need to find 940 front for the 9870 and then it's a complete unit. I was thinking about putting 800x38s on it with the spacers to go down meter rows but I'll do a few seasons with the duals and see how it works. No one has worn out a combine this year.

 

[BeckmanFarms]

The 2630 is different than the command arm due to the one on the command are does. It take into account the overlap control. The 2630 will shut off two rows of recording as you come to point rows or stop recording when you get into previous harvested crop.
Hope that helps

 

[s6704940]

The 2630 is different than the command arm due to the one on the command are does. It take into account the overlap control. The 2630 will shut off two rows of recording as you come to point rows or stop recording when you get into previous harvested crop.
Hope that helps

So isn't it possible to have overlap control on on both? I didn't think you could have a 2630 on the command arm and one on the cornerpost at the same time, thought if you have the 2630 up top then you have the small command center on armrest. Wouldn't two 2630's clash with each other from time to time.

 

[BeckmanFarms]

I went back and read what I wrote. Was bouncing in a tractor and fat fingered some stuff.
Yes you can run 2630s for the command arm and up to. The one on the command arm will give you machine functionality like settings just like the small command arm screen would.
The upper one will be your autotrac and mapping display. It will be the primary for those functions so it will take over for the overlap control.