The Combine Forum banner

3300 cylinder bar replacement

2052 Views 4 Replies 3 Participants Last post by  whtbaron
How do I know when to replace the cylinder bars in my 3300? Mine measure a little over 1/4" (around .270 with calipers). One side on all of them is a little deeper (about .030") than the other. I only saw one with a damaged tooth/rib. The reason I am inspecting them is I kept having problems with the combine cracking corn and milo last year. I made the obvious cylinder and tailings adjustments but I just wanted to check this before beginning to harvest this years crop.
1 - 1 of 5 Posts
New chrome bars will crack more till polished smooth. Make sure your cylinder speeds are correct and returns are low, that's what cracks grain.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top