The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
480 Posts
Discussion Starter · #1 ·
We are removing our 575R factory impeller, we've removed the nuts around the left side impeller access cover, we've removed the collar on the right side impeller bearing. Should it be loose now or are we doing it wrong? Maybe the right side bearing needs removing completely first? We used a ratchet strap as a come-along to apply some pulling force and then yanked on the strap yet too.
 

Attachments

·
Registered
Joined
·
480 Posts
Discussion Starter · #4 ·
Regarding the left bearing, do you mean the bearing behind the impeller drive pulley? We are planning to leave that pulley & bearing assembled to the impeller and just rebuild the impeller itself to resemble something like a Sunnybrook.

We want to put a knife in, I recently read on another thread, someone put a knife on the cylinder concaves to split the stream/mass before it reached the impeller.
 
1 - 3 of 3 Posts
Top