The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter · #1 ·
This is our first year with the 590r combine with a honeybee header. I hooked up the head the other day. Ran it today. Everything worked good except the reel speed was super fast. When I choose the reel with the rotary knob the cebis shows 11.8 mph. I drove around the yard a bit but no change in speed no matter how fast I was going. Is this a control valve problem or just a setting in the cebis? The owners manual hardly mentions this stuff. Thanks.
 

·
Registered
Joined
·
4,799 Posts
Can you slow it down manually using the knob an buttons? Usually if auto reel speed isn't working it's because the maximum cut height isn't set right.
 

·
Registered
Joined
·
57 Posts
Discussion Starter · #4 ·
It has the claas speed sensor. I cannot slow it down with the buttons. I assume I should be able to?
 

·
Registered
Joined
·
552 Posts
Turn the rotary dial to the reel and push the minus key that should slow it down. Also check that the reel speed linkage hasn't come off on the pump. It's located under clean grain unloading chain
 
1 - 5 of 5 Posts
Top