The Combine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
247 Posts
Discussion Starter #1
Is it possible to reset the concave indicator 0 point in the corner post display? I put small wire concaves in for wheat and reset the stops so now the corner post display is not right.
 

·
Registered
Joined
·
15 Posts
Close the concave all the way. Turn the key on and press the calibration screen select concave then enter and it should reset to zero. Also look in the operator manual will tell you how to do it.
 

·
Registered
Joined
·
3,334 Posts
i wish it was possible to go back to 0-8!!!!!!!!!!!!!!!!!!!!!!!! i hate the new number system... sorry to not help you and butt in... but i hate it!!!!!!!!!!!!!
 

·
Registered
Joined
·
247 Posts
Discussion Starter #5
Thanks slider2. I looked in the manual but didn't find it. Maybe I didn't look hard enough.
 
1 - 5 of 5 Posts
Top