The Combine Forum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
256 Posts
Discussion Starter · #1 ·
I can't get my 630D table to run level, always high on the rh end.

I have HHR, HHS and Contour Master on Auto, tech told me
I would have to take the contour master off Auto and control
it manually.

Any ideas would be appreciated.

MS
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top