[DGDeckard]

I'm new to the forum...thanks in advance.

I'm looking for instructions to remove and reinstall the auger on a JD 630F Hydra-Flex header. Also, an exploded view of parts would be very helpful.

Does anyone have experience with this task that I could contact for pointers?

 

[meritmat]

hehe not sure but I get to learn on a 930R once we get the replacement auger. Remove the reel first im told then the auger slides out some how, use a loader of course

 

[Tjohanson]

I have removed a few augers on new 600 series R and F headers. If you move the reel all the way up and forward you can then move the auger out of the top if you have two forklifts or lifting sources. If you dont have to change the insides of the auger you can take it out and back in in about a day. You can push the shaft on the left hand side in flush in the auger and leave the right hand side where it is. Start lifting the left side first then pick it out. Hope this helps.

 

[greentech]

Just use one forklift/loader and one lifting strap right in the center of the auger. Then you can tilt it as you lift out.

 

[greentech]

I have removed a few augers on new 600 series R and F headers. If you move the reel all the way up and forward you can then move the auger out of the top if you have two forklifts or lifting sources. If you dont have to change the insides of the auger you can take it out and back in in about a day. You can push the shaft on the left hand side in flush in the auger and leave the right hand side where it is. Start lifting the left side first then pick it out. Hope this helps.

Pretty sure right side comes out first, as left side is auger drive and that shaft is fixed in place.