The Combine Forum banner
1 - 3 of 3 Posts

· Registered
13 Posts
Discussion Starter · #1 ·
just wondering if anyone has a idea why a 640D on a 2010 9670 would be cutting higher on the right hand side the the left.
everytime the front cuts higher on the right hand side i find that the pressure on the hydraflew jumps up its self to over 2200psi, our deaker said to run the pressure at around 1700 and yeah just getting very annoying my pulling up all the time to lower the pressure so that the knife will cut even and not leave wheat behind
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.