The Combine Forum banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Last year I developed a problem when I was finishing up corn with the 6600. I was getting several whole, shelled cobs in the bin. I had a few very low yield areas where the problem seemed even worst. I was not able to determine how they were getting there. The sieve and the chaffer are in good shape and I get clean samples of wheat and soy beans. I haven’t gotten into corn yet this year, but I wanted to know if there is something I should check before I find I have this problem again.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.