The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
does anyone have experience with the jd 6600 sh ? my problem is the right hand drive shaft from the trans. output shaft to final drive keeps wearing out the splines about every 400 hours . only the right hand shaft does it and there isn't any apparent adjustment to make . seems like some have this problem and some don't . thought about putting a universal joint in to take the wobble out but there just isn't enough room for a joint that could take that kind of torque load.
 

·
Registered
Joined
·
11 Posts
Sounds like the bushings on the axle housing (final drive) that pivots are worn out. This will make the output shaft on the tranny and the input shaft on the final drive be out of alignment.
Tom
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
yeah that could be , although it seems the driveshaft bearing is independent of the housing that is bushed but i'll tear it apart during the summer here and see if that helps , thank you
 
1 - 3 of 3 Posts
Top