The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
I just did the same thing on our 7010 what I did was use the 2 existing plugsunderneath the cab that are a 3 prong female plug that are factory wired for european models that they use for headlights those plugs are wired all the way back to the fuse block and the relay to run them are all there the only thing you have to do to make those plugs hot is run a signal wire from your light switch in the cab to the relay that is in your relay stack that controls the low beam headlights for the european models american combines dont use that relay and fuse for anything so it is a way to add lights neatly and correctly be properly fused and come on and off with your standard cab work light switch and not have to run much wire
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top