The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
I find it hard to get as clean a sample without blowing wheat out the back of our 7010 as comparedto our previous 88 series combine. Read on a post that someome talked of plugging a hole between the presieve and sieve with foam. Can't find the post back but wondering if anyone else has done this and how they did it. I also think that the rotor loss sensors don't accuratley monitor the rotor loss and they often show up as chaffer loss esp. when your beater is on slow speed.
 

·
Registered
Joined
·
32 Posts
Go to www.newhollandrochester.com and click on the link 'Air Flow' and watch the video. It might be that your issues are from lack of air control. The video shows the New Holland brand but the shoe is essentially the same in the red side. There are two parts to the video.
 
1 - 4 of 4 Posts
Top