The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
Dana - you are not the first one this has happened to...

Have your dealer re-download ALL of the latest software in the Pro600 - even if it is already the latest version. This includes the header control as well as the other controllers. I know that version 16.2 works - not sure about other numbers.
 

·
Registered
Joined
·
12 Posts
Dana

Had the same problem when setting a new 7010 up in the field, This comine had all the current software. You are problably not setting your #1 or #2 header set function low enough to enable Auto Height control which will make the field tracker work in Auto.

Jeff
 

·
Registered
Joined
·
8 Posts
WE had the same problem! sat for 2 days in beans.
you have to set your head to pick up at least to 51% for it to trip for the tracker to work when you set it back down.
 

·
Registered
Joined
·
140 Posts
Cannot get corn head in auto mode, all I get is return to cut.
Dealer is going thru cih assist & I am the first that they have heard with this problem. Spent two hours this am on phone & still no luck. In return to cut all three sensors on the head act the same, just head height, no field tracker. It is a 2212 converted to a 2412 with factory kit. In 20 inch corn it is hard to see the snouts, sure would be nice if it worked.
tia
Dana
 
1 - 4 of 4 Posts
Top