The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
Have a 07 7010 and 30' 2020 and when i hit the resume button the head drops down to about 8 inches off the ground and holds there for about five seconds and then goes the rest of the way down. I have done the feeder cal and the cal were you hold the button down and up through the range and nothing helped. Its getting to be a real pain in our hills. Any help would be great thanks
 

·
Registered
Joined
·
102 Posts
With the feeder and separator running, try raising feeder all the way to the top and then push the #1 and #2 height buttons. Neither should light up but this will erase your cutting heights. Then lower header to your desired heights and set your #1 and #2 heights. I have had this work several times with what you described.
 
1 - 2 of 2 Posts
Top