The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
Tonight the right side impeller on the spreader fell off. Anyone else have this problem? Good thing is we found it, bad thing is how we found it is by running it over with cart tractor and ruining one year old rear tire. Didnt even hear or feel it come off. Anything need to know about putting back together? thanks
 

·
Registered
Joined
·
16 Posts
If it's the same as the 8010s, it has a half moon key that it slides over. It is held on by a bolt and washer.
All metric of course. We had the same one fall off. Probably just coincidence.
 

·
Registered
Joined
·
21 Posts
I have seen some fall off in the past, use a retaining compound on the shaft and locktite on the bolt. Make sure the fit on the shaft is close
 

·
Registered
Joined
·
37 Posts
There was a problem on the earlier 8010's with the motor shaft to impeller clearance. They had a campaign that the impeller retaining bolts were to have thread-locker applied, then reinstalled and torqued.
 
1 - 4 of 4 Posts
Top