The Combine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,142 Posts
Discussion Starter #1
we have a 07 7010 has had a few troubles in it life but none more dangerous than what happened today we were shifting the combine along the road when it hit a small bump in the road and stopped driving.
it said return the handle to neutral and start again so off we went about 200m down the road it goes again. after the fifth time it stopped and has not done it all day while harvesting any help would be good.
 

·
Registered
Joined
·
2,233 Posts
there is a micro switch on handle in consol that has given trouble, did you recalibrate, might fix your problem, scott.
 

·
Registered
Joined
·
106 Posts
The electronic shifter on the transmission sounds out of alignment. You can manually shift gears by taking off the cage, shields underneath. Once it does it once, it will not go away until it is repaired at the dealer.
 

·
Registered
Joined
·
423 Posts
it is the shifter on the transmission you need the dealer as traktorman says we had the same problem with a 2008 7010 there is a factory update we had it happen 3 times in one day.
 

·
Registered
Joined
·
1,142 Posts
Discussion Starter #5
thanks guys we have thought is was the shifter but we have just wondered if it may have been some thing else. got a mate thats was a case mech and he says to shime the shifter on the transmission and it will fix it but just wanted to see what everyone else had found.
 
1 - 5 of 5 Posts
Top