The Combine Forum banner
1 - 2 of 2 Posts

4 Posts
Discussion Starter · #1 ·
I have lost the ability to adjust the top sieve with the actuator. The assumption was the potentiometer had failled so I replaced actuator. No good. No response from in the cab or remotely at the back.

Both sieves run on the same fuse and the bottom is fine. Anyone had a similar problem?

Broken wire/plug or the relay is all I can think of.

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.