[MaluHarv]

Say i got a question for the people who run a 7010 or did run one....i just bought one and love it. ..my question is can i unload on go and get to end of rows shut down Unloader then start again once lined up on corn...... high moisture. ...24 to 32..... i used to do this frequently on my 2388 but then started to notice the panel brakeing out behind pulley...just want to see if i would find a similar problem on a 7010...thanks all..

 

[Ohio Farmer]

I havn't run a 7010 but i do that with my 2388. I always idle mine down before reengaging with a full auger and then throttle back up, that way you arn't slammin all that s%&t on with a full load !

 

[MaluHarv]

Thanks for the reply....yes after changing that rear panel i too would make sure tube was empty or engaged slow idle. ..

 

[snakebit]

I bought a 7010 in 09. It had an update kit so you could stop the grain tank augers and run the big auger empty. I think it is on all the flagship combines now.

 

[MaluHarv]

Thank you for the reply ...my combine only runs on one big chain and unloads all or nothing. ..i am just curious if unloading on go if i am going to wreck something. By not getting the tube empty then start it up when back in corn.....

 

[325mag]

It has been done by custom harvesters for years.