The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
117 Posts
Discussion Starter #1
Just got done doing some warranty work on 7088 shaker it had a bent chaffer pan and rails out of square (an odd problem on a new combine) I`m disappointed with how hard the job was to pull the sieves. Way to heavy why not make them two piece like the 8010 and the clearance on the back is way to tight to get them in and out without a struggle. The combine performs admirably in the field but many field repairs will take 2 people and unfortunately I`m usually alone, can`t wait
 

·
Registered
Joined
·
117 Posts
Discussion Starter #3
don`t know the rails were only off a little and I`ve never seen a grain pan bent up. The channel underneath is very thin.
 
1 - 4 of 4 Posts
Top